Eyelets, Rivets, Press Studs

5mm Inside Diameter
Packet of 50
Brass Eyelets and Rings in various sizes with a Punch and Die included for fitting.
Easy to use and ideal for a wide range of applications.
Enter the number of packets you require in the quantity box.

6mm Inside Diameter
Packet of 50
Brass Eyelets and Rings in various sizes with a Punch and Die included for fitting.
Easy to use and ideal for a wide range of applications.
Enter the number of packets you require in the quantity box.

8mm Inside Diameter
Packet of 25
Brass Eyelets and Rings in various sizes with a Punch and Die included for fitting.
Easy to use and ideal for a wide range of applications.
Enter the number of packets you require in the quantity box.

10mm Inside Diameter
Packet of 25
Brass Eyelets and Rings in various sizes with a Punch and Die included for fitting.
Easy to use and ideal for a wide range of applications.
Enter the number of packets you require in the quantity box.

12mm Inside Diameter
Packet of 25
Brass Eyelets and Rings in various sizes with a Punch and Die included for fitting.
Easy to use and ideal for a wide range of applications.
Enter the number of packets you require in the quantity box.

13mm Inside Diameter
Packet of 15
Brass Eyelets and Rings in various sizes with a Punch and Die included for fitting.
Easy to use and ideal for a wide range of applications.
Enter the number of packets you require in the quantity box.

Small Eyelet tool for fixing small nickel eyelets.

PACKET OF 25

Enter the number of packets you require in the quantity box.

This Eyelet tool can be used as a conventional hole punch (6 sizes supplied) on soft materials, or to join materials together using the special punch and die heads and eyelets supplied.

Supplied with a quantity of eyelets. Additional eyelets are available ...

Enter the number of packets you require in the quantity box.

PACKET OF 25
These rivets have two parts - a base and a cap.
The base is flat and leaves a flush finish, the cap is raised.
The base is placed upon a hard surface and the shank is pushed through the hole in the leather. The cap is placed over the base and then struck with a mallet or hammer.

PACKET OF 6 SETS
A snap fastener (also called snap, popper, and press stud) is a pair of interlocking discs commonly used in place of buttons to fasten clothing. A circular lip under one disc fits into a groove on the top of the other, holding them fast until a certain amount of force is applied.
Snaps can be attached to fabric by hammering (using a specific punch and die set) see below.